This state-of-the-art 66-channel DIYDrones MediaTek MT3329 GPS is built small and compact. An ideal GPS device for the Ardupilot Mega. 

The DIYDrones 3DR RadioTelemetry Kit is designed as an open source Xbee replacement radio set, offering a lower price, longer range and superior performance to Xbee radios. This is the 433Mhz version. (For Export Only)

The system provides a full-duplex link  using HopeRF's HM-TR and data modules running custom, open source firmware.  Interface to the module is via standard 5V-tolerant TTL serial / FTDI USB serial.

DIYDRones Remzibi's OSD is an On-Screen-Display unit that is used along with a video transmitter and video receiver on First-Person-View setups for Remote Control planes.

First-Person-View gives you a view from inside the cockpit of the R/C plane. If you connect video goggles or a monitor/TV to the output of the Video Receiver, you can actually see as if you were sitting inside the plane. 

The DIYDrones XtreamBee Board is the most advanced and competitive XBee interface board you will find! It's breadboard compatible, has 4 status LED's (one selectable to display ASC or RSSI), built-in 3.3V power regulator, configuration solder jumpers and an unique feature that allows you set the device as Master or Slave FTDI mode with a simple slide of a switch!  

This DIYDrones XtreamBee USB Adapter is a simple to use, USB to serial base unit for the XBee line. Plug the unit into the XBee Explorer, attach a mini USB cable, and you will have direct access to the serial and programming pins on the XBee unit. 

This DIYDrones HMC5883L Magnetometer is a 3-axis digital compass board based on the Honeywell's HMC5883L; this is the direct replacement for the previous part HMC5843-TR. This magnetometer can be used on the ArduPilotMega IMU Shield, the UAV DevBoard, ArduIMU+ or any microcontroller. By adding this accessory to your APM set up, you will give your vehicle an extra sense direction! This revision reduces the overall size of the board while keeping all of its previous features!

The DIYDrones MPXV7002 series piezoresistive transducer in the small outline package (SOP) is a state-of-the-art monolithic silicon pressure sensor designed for a wide range of applications, but particularly those employing a microcontroller or microprocessor with A/D inputs. This patented, single element transducer combines advanced micromachining techniques, thin-film metallization, and bipolar processing to provide an accurate, high level analog output signal that is proportional to the applied pressure. This is a stand-alone airspeed sensor. Includes Pitot Tube and 12cm Female to Female Servo Cable.

Back in Stock (Now includes Xbee-Oil Pan connector cable)
The DIYDrones Xbee Telemetry Kit is designed to allow the transmission of flight data from unmanned aerial drones and other small scale aviation platforms. In addition, it can be set up to allow ground to air control via a PC. 

Now with this ArduPilot Mega Case, specially designed by Peter Koppendorfer for the Ardupilot Mega and all of its components, you don't need to worry about damage caused by turbulence or accidents! Precision laser-cut plywood parts go together in minutes, and stand up to a beating while protecting your electronics. Cut-aways give access to all ports and pins. 

This magnetometer can be used on the ArduPilotMega IMU Shield, the UAV DevBoard, ArduIMU+ or any microcontroller. It is a 3-axis digital compass board based on the Honeywell's HMC5843. Communication with the DIYDrones HMC5843 is achieved through an I2C interface.